GSD

Lowara Pump Product

The Lowara GS series booster sets are fully automatic booster sets for water supply. They are equipped with 2-3 fixed speed pumps (where one can be a jockey pump), control panel, SM30 controller and pressure transmitters, all mounted on a frame for easy installation. The SM30 is easy to set and can be connected to a BMS system via Modbus.

HCP F Type General Sewage Pump Range

A precision manufactured motor is achieved utilizing the highesst standard of quality control, to ensure 100% quality manufactured motor with characteristics and a highest efficiency. All rotor adopted heat treatment method for drive shaft assembling and stator winding impregnated with varnish and heat dried in an industrial oven.

EBARA FS

Easy maintenance , BPO (Back Pull Out) feature removed without disconnecting suction and disch Top centreline discharge, foot support under misalignment and distortion from pipe loads.Non overload design to ensure stable performance. Wide range application with flow capacity up to 2 Higher working pressure up to 16 Bar.

4? Submersible Motors Super Stainless

These motors are built for dependable operation in 4″ diameter or larger water wells.

Flow inducer sleeve not required in water up 88° F (30°) for motors through 2hp

Two-wire motors are split-phase designs with integral starting components and do not require a control box. They feature Franklins patented 2-wire BIAC starting switch which provides Reverse Impact Torque to aid starting in adverse environments and prevents extreme fast cycling (e.g. water logged tank).

GRUNDFOS CR

The basic CR pump range, which can be applied in almost any industrial solution, is already in itself the broadest range available. Through our modular approuch, we have made it even broader.

The basic CR pump range is avilable in four different materials: cast iron, two grades of stainlesss steel, and all titanium. There are eleven flow sizes, capable of producting up to almost 50 bar of pressure, and with a variety of shaft seals, rubber materials and supply voltages.

Pump part which are typically vulnerable to difficult liquids or particularly demanding operating conditions can be optimised for their purpose and designed for specific requirements.

TORISHIMA ETA N

Centrifugal Back Pull Out Pump. End Suction Volute pumps with vertical centerline discharge. Back Pull Out (BPO) design allows the removal all rotating elements without disturbing the casing piping or motor. Standar Impeller Cast Iron. Option Inpeller Bronze